![math input panel 6.3 math input panel 6.3](https://i.ytimg.com/vi/0hcqtgpcZdg/maxresdefault.jpg)
The front-panel fiber-optic input adapter can be removed and cleaned as shown in the following picture. Use caution as fiber-optic end surfaces are easily damaged due to improper cleaning techniques and repairs can be expensive. To avoid damaging the N1092A/B/D's front-panel fiber-optic connector, use proper connection techniques.Ĭlick here to learn about fiber-optic connector care. Measurement results are generally 50% faster with the new N1092A/B/D due to a significantly faster sampling rate. Use FlexDCA SCPI programming tools to simplify conversion of legacy 86100-based automation to FlexDCA compatible code. Remote programs previously developed using the N1000A/86100D FlexDCA interface can be leveraged directly to control an automated N1092A/B/D system. The Trig'd and Armed indicators do not light unless the channel is turned on. The light is the same color as the displayed waveform. When on, the light indicates that the associated FlexDCA channel is turned on and that the waveform is displayed. This light is next to the fiber-optic input connector. This light is red if FlexDCA is in single/stop acquisition mode.Ĭhannel indicator light. Trigger light off indicates that the N1092A/B/D channel is turned off or if FlexDCA is in single/stop acquisition mode. Red Trigger light indicates that the clock input signal is missing. The trigger must be set to Front Panel and not Module. As with the DCA-X scope, this does not indicate that the trigger signal is synchronous with the channel input signal. Green Trigger light indicates that the N1092A/B/D is being triggered. The number indicates the channel, which in this picture would be channel 6A.
#Math input panel 6.3 software#
Click Software Delay and enter the desired delay.In the Setup dialog box, click Advanced for the channel.Click Setup > Modules > Channels and select the channel.Click Auto Scale to autoscale the lowest numbered channel.The delays are referenced to channel 1A because Auto Scale aligns on the lowest numbered channel that is displayed. For example, if channels 1A, 2A, and 3A are displayed, add software delay to channels 2A and 3A.
![math input panel 6.3 math input panel 6.3](https://media.springernature.com/lw785/springer-static/image/chp%3A10.1007%2F978-3-319-52452-8_6/MediaObjects/65470_4_En_6_Fig3_HTML.gif)
Although this technique works, acquisition throughput will be reduced. If Rapid Eye is not installed as described above, you can manually add software delay to channels.
![math input panel 6.3 math input panel 6.3](https://www.gottabemobile.com/wp-content/uploads/2008/10/mathinput1.jpg)
Select Align Channels During Auto Scale.The recommended input is Acquisition to open the Acquisition Setup dialog box. Maximum Clock In non-destruct input voltage is 1.4Vpp.